EBU18200 On-Command four-wheel-drive switch This ATV is equipped with a switch to change from two-wheel drive to four-wheel drive and vice-versa. Select the appropriate drive according to the ter- rain and the conditions. G “2WD” (two-wheel drive): Power is supplied to the rear wheels. G “4WD” (four-wheel drive): Power is supplied to the rear and front wheels. To change from two-wheel drive to four-wheel drive, stop the ATV and push the switch in to the “4WD” position. To change from four-wheel drive to two-wheel drive, stop the ATV and push the switch in to the “2WD” position. 4-5 EBU18100 Start switch “ Push this switch to crank the engine with the start- er.
See the starting instructions on page 6-1 prior EBU18160 Light switch “ / /OFF” Set this switch to “ ” to turn on the low beams, the taillight and the meter lighting. Set the switch to ” to turn on the high beams, the taillight and the meter lighting. Set the switch to “OFF” to turn off all the lights. Do not use the headlights with the engine turned off for an extended period of time, oth- erwise the battery may discharge to the point that the starter motor will not operate properly. If this should happen, remove the battery and to starting the engine. CAUTION: CAUTION: recharge it. ECB00050 ECB00040 4