Introduction General repair instructions Hose placement 1044-004 13989-003 NOTICE! Hoses laid in a straight line get shorter as the hydraulic pressure is built up. Valves may be torn off. ►Always install hoses with a slight slack. ►Install hoses so that no tension or compression loads will occur in any operating conditions. ►Check: If you shake the hose line in the middle between two brackets/connectors (e.g. clamps), the overall play of the hose line should be at least 1 cm. 5727-002 25 ►Do not install hose with a twist. ►Particularly if there is movement at the hose line. 26 5728-002 27 5729-002 ►Avoid external mechanical impacts on hoses.
►Avoid chafing the hoses against each other or against components through proper placement and fastening. ►Keep an adequate distance from components. ►Keep sharp-edged components covered at all times. ►When high outside temperatures are involved, install hose lines at a sufficient distance from components radiating heat. ►If necessary, protect hose by a protective guard. 5726-002 28 18 00 0296 433 2 - RHB Dieselmotor OM906/926LA - 10/2014