GETTING TO KNOW YOUR VEHICLE 15 In case the ignition switch does not change with the push of a button, the key fob may have a low or fully depleted battery. A low key fob battery can be verified by referring to the instrument cluster, which will display directions to follow. Vehicles Equipped With Keyless Enter ‘n Go™ — Passive Entry 1. Remove the emergency key by pushing the mechanical release button on the side of the key fob with your thumb and then pulling the key out with your other hand. If one or more doors are open, or the liftgate is open, the doors can be locked. The doors will unlock again only if the key fob is inside the passenger compartment. NOTE:
A low key fob battery condition may be indicated by a message in the instrument cluster display, or by the LED light on the key fob. If the LED key fob light no longer illuminates from key fob button pushes, then the key fob battery requires replacement. All doors can be programmed to unlock on the first push of the unlock button within Uconnect Settings Ъ page 189. Replacing The Battery In The Key Fob 2 The key fob LED light brightness is designed for indoor light viewing, so the LED light may not be visible in direct sunlight Ъ page 387. To Lock/Unlock The Doors And Liftgate The recommended replacement battery is one CR2032 battery. NOTE:
Customers are recommended to use a battery obtained from Mopar®. Aftermarket coin battery dimensions may not meet the original OEM coin battery dimensions. Emergency Key Removal 2. Insert a coin or a flat blade screw driver into the now exposed slot and carefully pry on both sides to disengage the snaps. Gently remove the back cover from the fob, being careful not to damage any of the snaps. Push and release the unlock button on the key fob once to unlock the driver’s front door and sliding door or twice within five seconds to unlock all doors and the liftgate. Push and release the lock button on the key fob to lock all doors and the liftgate. Batteries contain harmful chemicals.
Dispose old batteries by placing them in correct containers according to the law or by taking them to a dealership, where they will be handled appropriately. 3. Remove the battery by sliding the battery rearward in its pocket until the battery lifts up. Remove the depleted battery from the battery pocket and dispose appropriately. When the doors are unlocked, the turn signals will flash and the illuminated entry system will be activated. When the doors are locked, the turn signals will flash and the horn will chirp. Settings in the Uconnect system can change to lights only, chirp only, or both. Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazard- ouswaste/perchlorate for further information. Do not touch the battery terminals that are on the back housing or the printed circuit board. 4. Fit a new CR2032 battery ensuring that the positive (+) side is facing upwards. Push the battery into the pocket until it is firmly seated in place and secured under both tabs.