SAFETY SAFETY MACHINE OPERATION SAFETY RULES FOR TRAVELING q When traveling on flat ground, keep the work equipment 40 to 50 cm (15.8 to 19.7 in) high above the ground. q When traveling on rough ground, travel at low speed and do not operate the steering suddenly. There is danger that the machine may turn over. The work equipment may hit the ground surface and cause the machine to lose its balance, or may damage the machine or structures in the area. q When traveling on rough ground or steep slopes, if the machine is equipped with auto-deceleration, always turn the auto-deceleration switch OFF (cancel). q Avoid traveling over obstacles when possible.
If the machine has to travel over an obstacle, keep the work equipment close to the ground and travel at low speed. Never travel over obstacles which make the machine tilt strongly to one side. q When traveling or carrying out operations, always keep a safe distance from people, structures, or other machines to avoid coming into contact with them. q When passing over bridges or structures, check first that the structure is strong enough to support the weight of the machine. When traveling on public roads, check first with the relevant authorities and follow their instructions.
q When operating in tunnels, under bridges, under electric wires, or other places where the height is limited, operate slowly and be extremely careful not to let the work equipment hit anything. TRAVELING ON SLOPES To prevent the machine from tipping over or slipping to the side, always do as follows. q Keep the work equipment approx. 40 to 50 cm (15.8 to 19.7 in) above the ground. In case of emergency, lower the work equipment to the ground immediately to help stop the machine. q When travel up slopes, set the operator's cab facing uphill, when travel down slopes, set the operator's cab facing down- hill. Always check the firmness of the ground under the front of the machine when traveling.
2-25