OM4005 10/96 Maintenance - Section 4 Lubrication and Service Page 4-5 100 HOUR LUBRICATION AND MAINTENANCE CHECKS NOTE: 10 Hour service should be included with the following: Truck Serial Number ____________________________ Site Unit Number _____________________________ Date:______________Hour Meter_________________ Serviceperson Name___________________________ CAB a. Steering Column Linkage -- Use hand gun and lubricate with grease. Lube Key ‘‘E’’. (2 pts.) b. Cab Door Hinges -- Oil hinges as necessary. Lube Key ‘‘AA’’ (SAE 10W). Check door & windows for proper operation, correct as required. c. Cab Air Filter -- Clean or replace. d.
Cab Mounts -- Check rubber cab mounts, replace as required. e. Outside Mirrors And Lights -- Check for damage and operation, repair as required. f. Instrument Panel -- Check instruments for proper operation. Verify operation of all lights and warn- ing devices. Check alternator charging rate. Cor- rect as required. FRONT WHEEL -- Check front wheel bearing oil level. Lube Key ‘‘C’’. NOTE: To check oil in front wheel hub, rotate wheel hub until one fill/drain hole is horizontal, and the other is "up", add lube oil as required. THROTTLE CABLE LINKAGE -- Oil linkage with SAE 10W oil (Lube Key ‘‘AA’’).
BRAKES -- Check hydraulic brake control valve, brake cali- pers, brake pads, hoses and tubes for leaks or wear, repair as required. U-JOINTS/DRIVE SHAFTS -- Use hand gun and lubricate at grease fittings on the cross and bearing assemblies and splines. Lube Key ‘‘E’’ (6 pts.). FUEL TANK -- Drain water and sediment from fuel tank. HYDRAULIC TANK BREATHER -- Remove spin-on breathers and check breathers for cleanliness. Replace as necessary. COMMENTS √’d INITIALS