OM4005 10/96 Maintenance - Section 4 Lubrication and Service Page 4-11 5000 HOUR LUBRICATION AND MAINTENANCE CHECKS NOTE: All 10, 100, 250, and 1000 hour service points should be included with the following: Truck Serial Number ____________________________ Site Unit Number ______________________________ Date:______________Hour Meter_________________ Serviceperson Name___________________________ FRONT WHEELS - Drain oil and check bearing preload as covered in Section ‘‘G’’ of the Service Manual. Use Lube Key AIR CLEANER - Clean the Donaclone Tubes in the pre-cleaner section of the air filter. Use low pressure cold water or low pressure air to clean tubes. NOTE:
Do not use a hot pressure washer or high pressure air to clean tubes because pre-cleaner tubes will distort. STEERING CONTROL FILTER - Change in-line filter at orbitrol steering control unit inlet line. RADIATOR - Clean cooling system with a quality cleaning com- pound. Flush with water. Refill system with anti- freeze and water solution. Check Cooling System Recommendation Chart for correct mixture. Maintain cooling system according to engine manufacturer’s recommendations. NOTE: For additional or more specific information, refer to service manual. COMMENTS √’d INITIALS