(22) Place the distributor plate so that the channel holes match the holes in the housing. (780-3A) 5-82(3) (23) Guide the cardan shaft down into the bore so that the slot is parallel with the connection flange. (780-3A) 5-82(4) Place the cardan shaft as shown - so that it is held in position by the mounting fork. (24) (780-3A) 5-83(1) (25) Grease the two O-rings with mineral oil approx. viscosity 500 cSt at 20 C and place them in the two grooves in the gear rim. Fit the gearwheel and rim on the cardan shaft. (780-3A) 5-83(2) 5-42