Connector Repair Procedures 5-6 9. Evenly position supplied heat shrink tubing over wire repair. 10. Use shielded heat gun to heat the repaired area until adhesive flows out of both ends of the heat shrink tubing. 11. Reconnect battery ground cable. Recommended splicing method −Crimp (For 10−22 AWG Diameter Wire to Like Wire Diameter) 4. Select appropriate wire splice for the wires to be spliced. 5. Install the wire ends into the splice, making sure the ends of the wires are fully inserted. 6. Using the proper crimping tool for the splice, hand crimp the wires and splice. 7. Gently tug on the wires to be sure they are secure. 8.
Electrically check the circuit for continuity through the splice. 1. Disconnect battery ground cable. 2. Remove proper amount of insulation from each wire end, taking care not to nick or cut wire strands. 3. Install heat shrink tubing.