AIR CONDITIONING 1B-23 O-rings cannot be reused. Always replace with new ones. Tighten: Inlet line to 15 N m (1.5 kg m/11 lb ft) Tighten the outlet line to the specified torque. Be sure to apply new specified compressor oil to the O-rings when connecting refrigerant line. 3. Refrigerant Line Fixing Clamp 4. Pressure Switch Connector Tighten: Outlet line to 6 N m (0.6 kg m/4 lb ft) Condenser Assembly (4HK1-TC Engine Model For Australia) 2 1 4 3 N1A0198E Legend 1. Refrigerant line 3. Receiver / drier 2. Pressure switch 4. Condenser assembly Removal When removing the line, the connecting part should immediately be plugged or capped to pre- vent foreign matter from being mixed into the line. 2.
Condenser assembly Preparation: Disconnect the battery ground cable. Discharge and recover refrigerant. 1. Refrigerant Line Use a back up wrench when disconnecting and re- connecting the refrigerant lines.