Section 3 Dimensions 3-7 12/11 Detail Views Crossmember Locations – T170 Figure 3-6. T170 Crossmember Location TABLE 3-5 T170 Cross member. Location: measured from front axle centerlines [inches (mm)] WB A CB B CB C D E 206 101. 8 (2585) Y 121. 1(3075) Y 1. ) For without a square end of frame cross- member with an AF range of 80 (2032) 218 101. 8 (2585) Y 121. 1(3075) Y to 125(3175) a crossmember is installed at: 236 101. 8 (2585) Y 121. 1(3075) Y E=WB+64. 4”(1636mm) 245 101. 8 (2585) Y 121. 1(3075) Y 254 101. 8 (2585) Y 162 (4125) Y 2. ) For AF range of 126 (3200) to 173(4394) a WB A CB B CB C D E 206 101. 8 (2585) Y 121. 1(3075) Y 1.
) For without a square end of frame cross- member with an AF range of 80 (2032) to 125(3175) a crossmember is installed at: E=WB+64. 4”(1636mm) 2. ) For AF range of 126 (3200) to 173(4394) a 218 101. 8 (2585) Y 121. 1(3075) Y 236 101. 8 (2585) Y 121. 1(3075) Y 245 101. 8 (2585) Y 121. 1(3075) Y 254 101. 8 (2585) Y 162 (4125) Y 260 101. 8 (2585) Y 162 (4125) Y 2nd crossmember is installed at: E=WB+112. 4”(2855 mm) 272 101. 8 (2585) Y 162 (4125) Y Y SPL100 Driveline centerbearing (CB) is mounted on this crossmember.