8. Light Switch This switch is used to turn "ON" the lights. O I II O. In this position, all lights are "OFF." I. In this position, all illumination lights of the instrument panel and the control switches are turned "ON." II. In this position, all illumination lights and work lights are turned "ON." FG000024 CAUTION Figure 14 Do not leave instrument panel or work lights "ON" when the engine is not running. Leaving lights "ON" with the engine shut down will discharge batteries. 9. Breaker / Boost / Shear Selector Switch O I This switch is used to either select the breaker, power boost, or shear. II O.
In this position, a hydraulic pressure rise will be activated when pressing the button on the right-hand work lever (joystick). POWER UP I. In this position, shear is activated. II. In this position, breaker is activated. FG000025 Figure 15 WARNING Before using any attachment in a work application, be sure to check its functional control. Make sure that desired movement or action is being activated by the control. e.g. opening/closing, CW/CCW, crowd/dump, etc. 10. Cabin Work Light Switch (Optional) This switch is used to control the cabin work lights, if unit is equipped with them. O I II O. In this position, all cabin work lights are turned "OFF." I.
In this position, the front cabin work lights on the front top of cabin will turn "ON." II. In this position, the front cabin work lights on the front top of cabin and rear cabin work lights on rear top of cabin will turn "ON." FG000026 Figure 16 OP001760 Operating Controls 2-12