SECTION 2 SAFETY PRECAUTIONS Page 6 2.3. OPERATION On machines equipped with a suction fan or a reversible fan in the suction position, periodically check the engine exhaust system for leaks. Exhaust gases are dangerous to the operator. Do not operate the machine in a condition of extreme fatigue or illness. When pulling or towing with a chain or cable, take up the slack carefully. A sudden jerk could snap the chain or cable causing it to whip dangerously. Do not pull or tow unless the operator compartment is guarded against a whipping chain or cable. Clear personnel from the area. Be sure that the rear screen is securely fastened to the R.O.P.S. structure.
Be sure chains or cables and their anchor points are strong enough to handle expected load. Inspect carefully for flaws before using. Always wear gloves when handling cables and chains. Avoid looping or knotting the cable or chain. Do not pull with kinked chain or cable as excessively high stress in area of bending may cause a failure in the kinked area. Cables or chains for towing or winching should be fastened to the designated to this purpose attachment points only. Be sure pins are attached securely before pulling. Stand clear of chains or cables under load. Keep engine exhaust system and exhaust manifold clear of combustible material for your personal protection.
Know the locations of underground cables, water mains, gas lines, etc. A ruptured gas line or cut electrical cable could result in personal injury or death. When leaving the machine unattended for any length of time, make sure the transmission shift lever is positioned and locked in neutral (N), the blade is completely lowered, the engine is stopped, the parking brake is applied, and the electrical master switch is in the “off” position. If the machine is equipped with a cab make sure that the cab is locked. Before operating the machine read and know the Operator’s Manual and all Safety Product Graphic.
The roll-over protective structure (ROPS) provides operator protection in the event of machine rollover or upset. This structure is designed to bend during a rollover to protect the operator from sudden impact loads. Do not smoke when refueling or servicing the machine. A fire could result. Never place gasoline or diesel fuel in an open pan. When operating the machine, look in the intended direction of travel to be sure personnel or allied equipment does not interfere with the machine work pattern. Never try to get on or off the machine while it is moving. A serious injury or death could result. Never shift the transmission into neutral (N) when traveling downhill.
The machine may go out of control and a rollover could result or the transmission, torque converter or engine could be damaged when the transmission is again placed in gear. Always put the transmission in low range position before starting downhill. Use the decelerator and brake pedal to slow the machine. Avoid side hill travel whenever possible. Drive straight up and down the slope. If the machine starts slipping sideways on a grade, turn downhill immediately. If possible avoid crossing obstacles such as ridges, rocks or logs. If you can't avoid them, reduce speed and ease over the obstacle at an angle. TD-20H DRESSTA