REFERENCE ONLY 140497 PN=42 S11.0MOE. AT ·19·17FEB93 A-Hand Throttle B-Reset Button C-Key Switch D-Oil Pressure Gauge Engine Operating Guidelines 34 5. If equipped, depress and hold reset button (8) while starting. IMPORTANT: Do not operate the starter for more than 30 seconds at a time. To do so may overheat the starter. If the engine does not start the first time, wait at least 2 minutes before trying again. If engine does not start after four attempts, see Troubleshooting Section. 6. Turn the key switch (C) clockwise to crank the engine. When the engine starts, release the key so that it returns to the "ON" position. IMPORTANT:
If the key switch is released before the engine starts, wait until the starter and the engine stop turning before trying again. This will prevent possible damage to the starter and/or flywheel. 7. After the engine starts, continue to hold the reset button in until the oil pressure gauge (D) reads at least 103 kPa (1.03 bar) (15 psi). The safety controls will not allow the engine to run at a lower oil pressure unless the reset button is held in. IMPORTANT: Should the engine die when operating under load, immediately disengage PTO and restart the engine to prevent overheating of turbocharged parts, caused when the flow of oil for cooling and lubrication is stopped. B.
Check all gauges for normal engine operation. If operation is not normal, stop the engine and determine the cause. 4. Pull hand throttle (A) 1/3 of the way out. Turn the handle in either direction to lock it in place.