Н Route the fuel tank drain hose to the inside of the leads and fuel hose, making sure to position the end of the drain hose as shown in the illus- tration. О Fasten the final gear case breather hose, ground lead, starter motor lead, fuel injector lead, coolant temperature sensor lead, AC mag- neto lead, and wire harness with the plastic band, making sure to position the band near the split in the wire harness. П Route the fuel injector lead and coolant temper- ature sensor lead to the inside of the ground lead, starter motor lead, final gear case breather hose, and wire harness. Р Face the end of the plastic band inward.
С Pass the plastic band through the hole in the plastic cover, and then fasten the leads and hose with the band, making sure to face the end of the band downward. Т Insert the projection on the coupler into the hole in the frame from the inside of the frame. SPEC CABLE ROUTING 5 6 7 8 É Ê 3È4 9 0 A B C DË 2 1 B Ï B C E A C N Î A E D F Ì M E D L K F F JÍ I H G 5 6 B 2 7 Ð 6 5 1 P N L Ñ O 7 Ò 1 A-A B-B C-C I Õ Ö B B I G H C Ô A Ó Ó D-D D-D E-E F-F