Safety information D Do not tighten or loosen pipes and hoses that are under pressure (lubricant circuit, coolant circuit and any downstream hydraulic oil circuits): Risk of injury caused by liquids escaping under pressure D Do not place hands under the fuel jet when checking injection nozzles. Do not inhale fuel mist D Always disconnect battery when working on the electrical system D Do not use rapid charger to start the engine. Rapid charging of batteries is only per- mitted with the positive and negative leads disconnected! D Disconnect batteries only with the ignition turned off D Observe manufacturer’s instructions for handling batteries. Caution: Battery acid is toxic and corrosive.
Battery gasses are explosive D Only use suitable measuring instruments to measure voltages ! The minimum input resistance of a measuring instrument should be 10 M Ω D Only disconnect or connect wiring harness connectors on electronic control units with the ignition turned off! Disconnect batteries and connect the positive lead to the negative lead such that they are electrically conductive before carrying out any electric welding work. Earth the welding set as close to the weld as possible. Do not place cables of welding set parallel to electrical lines in the vehicle. Refer to the “Welders Code of Practice” for further accident prevention measures.
D When carrying out repaint jobs , electronic components may be subject to high tem- peratures (max. 95 ° C) for only very short periods; a period of up to approx. 2 hours is permissible at a max. temperature of 85 ° C, disconnect batteries Limitation of liability for parts and accessories In your own interest, we strongly recommend you use only accessories and original MAN parts expressly approved by MAN for your MAN engine. The reliability, safety and suitability of these parts and accessories have been tested specially for MAN engines.
Despite us keeping a constant eye on the market, we cannot assess and be held responsible for these properties in other products, even if they bear TЬV (German test- ing and inspection institute) approval or any other official approval in any particular case. Laying up or storage Special measures must be implemented in accordance with MAN Company Standard M 3069 Part 3 if en- gines are to be laid up or placed into storage for more than 3 months. 4