Return to Master Table of Contents 4. Tap two bolts into cover of cylinder head, 180° apart. Tighten them in a staggered, even sequence, to back off piston rod end cover from edge of cylinder wall. Look for adequate clearance between cover and end of cylinder wall before using a plastic or other soft-faced hammer for final disassembly. 5. Begin withdrawing piston rod assembly, away from cylinder. Attach a lifting support when final 1/3 of rod is still inside barrel of cylinder. Prepare support blocks for piston rod before it has been completely withdrawn. Figure 11 Figure 12 6. Lower piston rod to support blocks and detach wear ring (outer surface) (18) from end of rod.
Figure 13 S0705000 Page 11 Cylinders