Return to Master Table of Contents REASSEMBLY IMPORTANT Replace any part that shows evidence of damage or excessive wear. Replacement of all O-rings and flexible seals is strongly recommended. Before starting the cylinder reassembly procedure, all parts should be thoroughly cleaned and dried, and/or prelubricated with clean hydraulic fluid. Prepare the work area beforehand to maintain cleanliness during the reassembly procedure. NOTE: Reassemble the subassemblies of the cylinder in the following order: 1. Body of the cylinder 2. Piston rod 3. Piston assembly 4. Cylinder head assembly 1. Reassemble pin bushing (1) to piston rod (13) and body of cylinder (14). Figure 25 2.
Following reassembly of rod cover components, install the dust wiper (2) and rod bushing (6) to the rod cover (9). Insert retaining rings (3 and 8). Figure 26 S0705000 Page 16 Cylinders