. OPERATION MACHINE OPERATIONS AND CONTROLS Seat Belt WARNING 3 - 50 damage, replace. Even if there appear s to be no abnormality in the s eat belt, replace the seat belt onc e every 3 years. Th e date of manufacture is woven on the rev erse side of the belt. Adjust and fasten th e seat belt before operating t Always use the seat belt when operating the mach D o not use the seat belt with either half of the belt Check the mounting bolts of the belt fitting on t he machine body f or loosenes s, and re-tighten them if necessary.
The tightening torqu e for the mounting bolt is 2 4.5 ± 4.9 N·m (2.5 ± 0.5 kgf·m If th e belt surface is scratched or frayed or if th e fittings are broke n or deform ed, replace the s Fastening and Remo ving so that the operator still feels that there is 1. 2. ( l 3. r 1. Adjust the seat sufficient knee room when fully depressin g the pedal while e backrest. seated, with the operator's back against th 2. After adjusting th e seat poaition, sit in the s eat. Grip buckle (1) and tongue (2) i n each hand and insert ton gue (2) into buckle 1). Confirm by pulling the belt that the tongue is securely ckle. the belt, raise the tip of buckle (1) lever to ocked to the bu 3. When removing elease it.
Fasten belt along yo ur body without kinking it. Adjust the lengths of the belt o n the tongue side