. OPERATION DETAILED CONTROLS AND GAUGES Work Equipment Control Lever WARNING A: Canopy specification B: Cab specification This left work equipmentcontrol lever (2) is used to operate the arm and upper structure. Swing operation (a) Swing to right (b) Swing to left Arm operation (c) Arm IN (d) Arm OUT N (Neutral): The upper structure and arm are held in that position when they come to a stop and do not move. This right work equipment control lever (3) is used to operate the arm and upper structure. Boom operation (e) RAISE (f) LOWER Bucket operation (g) DUMP (h) CURL N (Neutral): The boom and bucket are held in that position when they come to a stop and do not move. 3 - 18 The pattern).
When changin distributor. The method of using operating patterns other than the ISO pattern is given in the ATTACHMENT AN D OPTIO NS section. Always understand the contents befor e operatin g the machine. When same changing time to t the operating p he operating pl attern, ch ate that ange t matche he s operating plate a the movement o t the f the machine. The place to attach the operating plate is on the right side of the operator's cab. operator's c ab. pattern (ISO