5 HD325, 405-6 Order of work Work procedure 1. Remove each mounting pin from the frame. 2. Fix the suspension cylinder. 3. Secure the A-arm. 4. Secure the steering cylinder. 5. Secure the tie rod. 6. Connect the brake hose/suspension control hose (5 pieces). • Since different pins are used for different parts, classify them so that they will not be mixed up. • Observe the tightening torque shown in the figure. • Observe the tightening torque shown in the figure. • Check the numbering of the hose on the axle side and the block on the frame side. (1, 2, 3, 4, and 5 from the front end)