PARTS CATALOG GUIDE Each page of the Figure Parts Detail will contain one or more rows of information, contained in the columns shown below: The first column is a reference number used to find the part on the Illustration (if not a Non-Illustrated Figure), the second column is the Part Number, the third column contains the number of the items used, the next column contains the Part Description, the fifth column contains any Kit References, the sixth column contains the Variation Number and the last column contains references to either Illustrated or Non-Illustrated Figures, that provide more detail by exploding the part. The third line refers to a Reference Figure.
Reference Figures are designated by being colored green in the Figure Parts Detail Lines. Examples are lines 3, 4 and 5 in the Parts Figure Detail shown above. Reference Figures have their own Parts Illustration and detail. All Reference Figures associated with a Figure are shown immediately below their parent Figure in the Book- marks Window. They have the following Icon associated with them; Reference Figure Icon Notice that line 1 and 2 of the Parts Figure Detail shown above are colored red. This indicates they are Non-Illustrated Reference Figures. These may be present in either Figures or Reference Figures.
Although these items do not have an illustration, they do contain additional detail about the part. These items are expanded below all other parts in either a Figure or Reference Figure Parts Detail listing at the end of the listing, as shown below: Notice that the Reference Figure 479929C4 shown in the above Non-Illustrated Reference Figure. This is the green line. This Reference Figure will be listed in the Booksmarks Window, immediately after the Figure. Non-Illustrated Reference Figures may also contain references to additional Non-Illustrated Reference Figures. In this case the lines will be red.
These Non-Illustrated Reference Figures will be expanded at bottom of the Figure Some Figures and Reference Figures will make reference to kits. The kit reference will be shown in the Qty column as "KT". This will be followed by (CONSISTS OF PARTS DENOTED BY KA) where KA is the kit identifier. There may be several kits in a figure detail, each denoted by a a different kit identifier, ie: KA, KB, KC, etc. This can be seen on the next diagram. Alias Figure Icon An Alias Icon represents a Figure that is in another section of the catalog. Clicking on the Alias Figure will take you to that section. For example: You may be looking for vehicle brakes.
On a front wheel driving axle, the brakes may be in Section 02 - Front Axles. This lets you find the brakes in Section 04 - Brakes, where you may expect them to be. Page No. 26 COPYRIGHT© 2011INTERNATIONAL TRUCK AND ENGINE CORP. COPYRIGHT© 2011INTERNATIONAL TRUCK AND ENGINE CORP.