SAFE OPERATION - 5 2. Keep the PTO shaft cover in place at all times. Replace the PTO shaft cap when the shaft is not in use. 3. To avoid injury from separation: Do not extend lift rod beyond the groove on the threaded rod. (1) PTO Shaft cover (2) PTO Shaft cap (1) Groove 3. Before installing or using PTO driven equipment, read the manufacturer's manual and review the safety labels attached to the equipment. To prevent PTO driven equipment from improper or unsafe use, select the lower speed (540rpm) unless the higher one is specifically recommended as safe by the equipment manufacturer. 4.
When operating stationary PTO driven equipment, always apply the tractor parking brake and place chocks behind and in front of the rear wheels. Stay clear of all rotating parts. Never step over rotating parts. 4. Use [UP-DOWN] switch or dial only on farm fields. For all other application, use depth control dial (hydraulic dial) to move attachment. 6. SERVICING THE TRACTOR Before servicing the tractor, park it on a firm, flat and level surface, set the parking brake, lower all implements to the ground, place the shuttle lever in neutral, stop the engine and remove the key. 1. Allow the tractor time to cool off before working on or near the engine, muffler, radiator, etc. 2.
Do not remove radiator cap while coolant is hot. When cool, slowly rotate cap to the first stop and allow sufficient time for excess pressure to escape before removing the cap completely. If the tractor has a coolant recovery tank, add coolant or water to the tank, not the radiator. (See "Checking Coolant Level" in "DAILY CHECK" in "PERIODIC SERVICE" section.) 3. Always stop the engine before refueling. Avoid spills and overfilling. 4. Do not smoke when working around battery or when refueling. Keep all sparks and flames away from battery and fuel tank. The battery presents an explosive hazard, because it gives off hydrogen and oxygen especially when recharging. 5.
Before "jump starting" a dead battery, read and follow all of the instructions. (See "JUMP STARTING" in "OPERATING THE ENGINE" section.) 6. Keep first aid kit and fire extinguisher handy at all times. 7. Disconnect the battery's ground cable before working on or near electric components. 5. USING 3-POINT HITCH 1. Use the 3-point hitch only with equipment designed for 3-point hitch usage. 2. When using a 3-point hitch mounted implement, be sure to install the proper counterbalance weight on the front of the tractor.