FOOT PEDALS 4.2 Angle Adjustment The foot pedal angle can be verified and / or adjusted to provide operator comfort and proper pedal travel clear- ance. Note: If the operator feels discomfort due to current pedal angles, they may be adjusted to their preference. Be sure to check for pedal travel clearance afterward. Always maintain a minimum of 3/8’’ (6mm) of thread into the cable clevis and eyelet cable ends. (fig. C3563) 1 Make sure the cable ends are screwed onto the cable threads a minimum of 3/8’’ (6mm). (fig. C3563) 2 Place an angle finder on the inner ROPS frame bot- tom of the loader to find the base measurement. Note the reading. (fig.
C3564) Jam nut Cable Rod End C3563 Maintain 3/8’’ (6mm) thread contact 4 Checking the base angle 3 Place the angle finder on the heel of the pedal to be checked or adjusted. (fig. C3565) Note the reading. C3564 Angle finder 4 Adjust the pedal angles by turning the rod ends on the end of the linkage attached to the pedals. Adjust the lift and tilt pedal angle to 20є.Be sure to allow for the base angle measurement taken previously. Example: If the base angle measured 3є, add or subtract that angle from the angle measured on the pedal. Checking the pedal angle C3565 4-10