Cable Replacement Check cable ends, eyelets or rod ends, and mounting pins for wear before removing the cable. Replace worn parts when replacing new cables. Cable ends should be inspect- ed every 150 hours of operation. 1 Raise the boom arms, engage the boom supports and shut off the engine. WARNING Never work under the boom arms without the boom supports engaged. C3876 2 Remove the seat and hydrostatic shield. Unfasten control lever plates and disconnect the throttle. Slide boots over the handles so that the control levers are easily accessible. (fig. C3876 and fig. 3848) 4 3 Loosen jam nuts on the cable rod end and eyelet end. (fig. C3847 and fig.
C3849) 4 Loosen the cable nuts on the control lever and the trans plate. (fig. C3847 and fig. C3848) 5 Remove cotter pins from lever base assembly end of the cable and remove the clevis pins. (fig. C3848) C3847 6 Unbolt eyelet end of the cable, then remove the cable. 7 Remove the clevis and eyelet ends of the cable and reuse them if still serviceable. 8 Install the new cable in the reverse order above. There must be a minimum of 3/8’’ (6mm) of thread engagement into the cable rod end and eyelet ends. Note: After installation of a new cable, the control lever angle will need to be verified and adjusted if nec- essary. Refer to page 4-15. C3849 HAND CONTROLS 4.3 C3848 C3848 4-13