HS120V DRIVING & CHASSIS - WORKING SYSTEM INSTALLATION LOCK PIN ADJUSTMENT G5:9HM:=FGH 8F=J=B;7 756=B 9B;=B9 9@97HF=7GMGH9A =B89L 5 Hand lever 7 6 PP PP Min 8 18 9 Release position A 11 13 10 17 16 PP PP PP B 15 12 Max 14 Lock position Lock pin A A - A LF1W325A LF1W326A (5) Hex. bolt (6) Plain washer (7) Spring (8) Control unit (9) Spring pin (10) Pin (11) Bolt (12) Washer (13) Spacer (14) Pin (15) Bolt (16) Pin (17) Nut (18) Hand lever 1. Park the vehicle on level ground. 2. Stop the engine. 3. After pushing up the hand lever of the attachment holder, check that the lock pin is out of the bucket slot (in the release position). 4.
Measure the distance from the top of the attachment holder to the pin end. (If the distance is not 393 mm, adjust the bolt (B) to set the distance to 393 mm. 1. Align the attachment holder with the boom. 2. Place a hydraulic jack under the attachment holder and raise the attachment holder until its bushing is aligned with the hinge of the boom. 5. Perform this procedure on the opposite side. 3. Install the boom pin (14), and then install the bolt (11), spacer, and washer. 4. After installing the bucket cylinder pin (16), install the bolt (15) and nut (17). 5. Grease the pins (14 & 16) through the grease fitting. Hex. bolt (5) Tightening torque ........
42.1 ~ 58.8 Nm 4.3 ~ 6.0 kgf-m 31.0 ~ 43.3 lb-ft 3 -15 GMW-0035