v 2. Service standards table Only the relevant service standards are shown. Service standards Unit: mm (in.) Location Maintenance item Standard value Limit Remedy 3, 10 Impeller-to-water pump shaft interference [Basic diameter: 13 mm (0.512 in.)] 0.03 to 0.06 (0.00118 to 0.00236) – Reassembly allowed only twice 4, 10 Flange-to-water pump shaft interference [Basic diameter: 26 mm (1.02 in.)] 0.05 to 0.08 (0.00197 to 0.00315) – Reassembly allowed only twice This shows the key No. of the relevant part. 3. Tightening torque table This shows specified tightening torque. Tightening torques Unit:
N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 1 Bolt (water pump assembly mounting) 9.8 (1.0) [7.23] Wet This shows the key No. of the relevant part. This shows that the item is to be tightened wet. 4. Lubricants and sealant table Only the relevant lubricants and sealant are shown. This shows the application point. Lubricants and sealant Location Points of applicatio n Kinds Quantity 6, 8 Bearings Wheel bearing grease [NLGI No. 2 (Li soap)] As required 11 Unit seal outer periphery THREEBOND 1102 As required 12 Grease nipple Wheel bearing grease [NLGI No. 2 (Li soap)] 60 g (2.12 oz) This shows the key No. of the relevant part. This shows the specified brand.