Safety Use Steps and Handholds Correctly Prevent falls by facing the machine when getting on and off. Maintain 3-point contact with steps, handholds, and handrails. T133468 —UN—30AUG00 Use extra care when mud, snow, or moisture present slippery conditions. Keep steps clean and free of grease or oil. Never jump when exiting machine. Never mount or dismount a moving machine. DX,WW,MOUNT -19-12OCT11-1/1 Read Operator Manuals for ISOBUS Implements In addition to GreenStar Applications, this display can be used as a display device for any implement that meets ISO 11783 standard. This includes capability to control ISOBUS implements.
When used in this manner, information and implement control functions placed on the display are provided by the implement and are the responsibility of the implement manufacturer. Some of these implement functions could provide a hazard either to the Operator or a bystander. Read the operator manual provided by the implement manufacturer and observe all safety messages in manual and on implement prior to use. NOTE: ISOBUS refers to the ISO Standard 11783 DX,WW,ISOBUS -19-19AUG09-1/1 Use Seat Belt Properly Use a seat belt when you operate with a roll-over protective structure (ROPS) or cab to minimize chance of injury from an accident such as an overturn.
Do not use a seat belt if operating without a ROPS or cab. Replace entire seat belt if mounting hardware, buckle, belt, or retractor show signs of damage. TS205 —UN—23AUG88 Inspect seat belt and mounting hardware at least once a year. Look for signs of loose hardware or belt damage, such as cuts, fraying, extreme or unusual wear, discoloration, or abrasion. Replace only with replacement parts approved for your machine. See your John Deere dealer. DX,ROPS1 -19-29OCT07-1/1 Vibration Measures to reduce vibration may include: Appropriate style of driving, e.g.
not too fast Suspended front axle Suspended cab Correctly adjusted operator's seat Correct tire pressure All operator's seats approved by John Deere are component type-approved in accordance with 78/764/EEC, being allocated an average of the vibration acceleration actually measured at the seat (a wS ), equivalent to ≤1.25 m/s І . This value must NOT be used to calculate vibration stress as per 2002/44/EC! Local John Deere dealers can provide assistance in assessing vibration stress. DX,VIBRATION,EU -19-19AUG09-1/1 05-5 030612 PN=14