TABLE III-I. INSPECTION REPORT (cont.) PIPER COMANCHE SERVICE MANUAL I ; I I I , ID24 RE ISED / / V :11 1 82 INSPECTI Nature of Inspection D. CABIN GROUP (eont.) 7. Inspect control wheels, column, pulleys and cables ligh• t'" s.. •" .• .• ,,. .•.'" :'I) ."... ," ." ,• • .'III ,III .ill .• .• 8. Check landing. navigation. cabin and instrument , 9. Inspect instruments, lines and attachments anill d" • r• e• p" l" ac.. e" .. f. i. l.. t. e.. r. ,. . ... ... .. .III.It .• ." ." ." ."."...... 10. Inspect instruments. central air filter lines II. Inspect condition of vacuum operated instruments and operation of electric turn and bank (Overhaul or replace as required) .. , . , ......... 12.
Replace vacuum regulator filter ..................•................... 13. Replace filters, if equipped, in gyro horizon and directional gyro ..............................................•.•...•......... 14. Inspect altimeter (Calibrate altimeter system in accordance with FAR 91.170, if appropriate) .................................... IS. Inspect operation of fuel selector valve (See Note 14) .....•...•.......•. , 16. Inspect oxygen outlets for defects and corrosion .•...........•......... . 17. Inspect oxygen system operation and components .....•.........•...... E. FUSELAGE AND EMPENNAGE GROUP I. Remove inspection panels and plates ..................•......•••..... 2.
Check fluid in brake reservoir (Fill as required) .....•.•.•...•.......... 3. Inspect battery. box and cables (Check at least every 30 days. Flush box as required and fill battery per instructions in Service Manual) ....................•........•................... 4. Inspect electronic installations ............................•.•.....•.. S. Inspect bulkheads and stringers for damage .....•..................... 6. Inspect loop and loop mount, antenna mount and electric I wiring .................•....•..........•••.....•....•.•........... 7. Inspect E.L.1. installation and condition of battery and I I antenna (See latest revision Piper S/L No. 820) ....................•... i 8. Remove.
drain. and clean fuel filter bowl and screen (Drain I; and clean at least every 90 days) ..................................... 9. Inspect fuel lines, valves and gauges for damage and I operation (See Note 13)....................•....•....•..........•... 10. Inspect security of all lines .......................................... II. Inspect stabilator and stabilator trim tabs for security of mounting, free play of components and ease of operation (Refer to Service Manual)...................•....•.................. 12.
Inspect stabilator bearings, bungee, and stabilator trim horns control rod and trim mechanism for security of installation, damage and operation (Refer to latest Piper Service Bulletin .. No. 464) ...........................................•.............. 13. Inspect stabilator tip balance weight arm for cracks ... I ill .... III ......... " oil"' ...... Inspection Time (hrs.) SO 100 0 0 0 0 , 0 I 0 I 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 500 1000 0 0 0 0 0 0 0 0 0 0 i 0 0 0 0 0 0 0 0 0 0 0 I 0 -- 0 0 I ,I i I 0 I 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0