Contents Page Page Lateral Tilt Feeder House ............................. 120-B-4 Separator Variable Speed Driven/Driver Sheaves ............................. 120-B-4 Separator Variable Speed Driven/Driver Sheaves (S780 and S790 Machines) ....................................... 120-B-5 Cleaning Fan Variable Upper and Lower Sheaves ........................................ 120-B-5 Fuel Precleaner Filter ................................... 120-B-5 Two-Speed Separator Drive Oil.................... 120-B-6 Water Separator Primary Fuel Filter............. 120-B-6 Radiator, Charge Air Cooler, Oil Cooler, and Condenser.........................................
120-B-7 Mass Flow Sensor........................................ 120-B-7 Cab Fresh Air Filter ...................................... 120-B-7 ActiveVision™Clean Grain Elevator Camera (If Equipped)...............................
120-B-8 Unloading Auger Upper Gear Case..............120-G-4 Header/Reel Drive Pump Sheave Bearing...120-G-5 Primary Countershaft Universal Joint Spline (Non-Multi-Speed Feeder House)......................................................120-G-5 Vertical Unloading Auger Upper Gear Case (S780 and S790 Machines) ............120-G-5 Chopper/Unloading Driveshaft Bearing........120-G-6 Variable Speed Driver Sheave .....................120-G-6 Feed Accelerator Bearings...........................120-G-6 Service Interval Chart—Every 400 Hours (Continued)....................................120-G-7 Tailings Auger Drive Slip Clutch (S760 and S770 Machines) ................................120-G-7 Conveyor Auger Drive Slip Clutch................120-G-8 Right-Hand Side Lube Bank.........................120-G-8 Overshot Beater Bearings (Optional) (S770, S780, and S790 Machines) ..........120-G-8 Discharge Beater Bearings...........................120-G-9 Cleaning Fan Shaft Bearings........................120-G-9 Rear Axle Tie Rod ........................................120-G-9 Spreader Disk (If Equipped) .......................120-G-10 Overshot Beater Gear Case Oil (Optional) (S770, S780, and S790 Machines)...............................................120-G-10 Separator Drive Oil.....................................120-G-10 Final Drive Oil.............................................120-G-11 Service Interval Chart—Every 400 Hours (Continued)..................................120-G-12 Transmission Oil (S760 and S770 Non-ProDrive™Machines) ....................120-G-13 Park Brake Cylinder Cables (S760 and S770 Push-Button Shift Transmission Machines) ........................120-G-13 Final Drive Couplers...................................120-G-13 Batteries .....................................................120-G-14 Hydraulic/Hydrostatic Filter (S760 and S770 Machines) .....................................120-G-14 Hydrostatic Charge Filter............................120-G-15 Main Engine Gear Case Filter ....................120-G-15 Engine Debris Management Air Filter (Final Tier 4/Stage IV Engines) ..............120-G-16 Fire Extinguishers.......................................120-G-16 Primary Countershaft Gear Case Oil (Fixed Speed and Variable Speed Feeder House Drive)..............................120-G-16 Brake Fluid (S760 and S770 Non-ProDrive™Machines) ....................120-G-17 Seat Belts ...................................................120-G-17 ProDrive™/Main Engine Gear Case Lube Filter (ProDrive™Machines).........120-G-17 Feeder House Slip Clutch...........................120-G-18 Multi-Speed Feeder House Drive (S770, S780, and S790 Machines) ........120-G-18 Loading Auger Gear Case Oil ....................120-G-18 Maintenance—First 100 Hours Service Interval Chart—First 100 Hours.......120-C-1 Main Engine Gear Case Filter (S760 and S770 ProDrive™Machines)..............120-C-1 Main Engine Gear Case Lube Filter (ProDrive™Machines).............................120-C-1 Maintenance—Every 100 Hours Service Interval Chart—Every 100 Hours.....120-D-1 Tire Pressure and Bolt Torque......................120-D-1 Maintenance—Every 200 Hours Service Interval Chart—Every 200 Hours.....
120-E-1 Recirculating Filter........................................ 120-E-1 Primary Countershaft (Multi-Speed Feeder House on S770, S780, and S790 Machines) ....................................... 120-E-2 Separator Variable Speed Driven/Driver Sheaves (S760 and S770 Machines) ....................................... 120-E-2 Maintenance—Every 250 Hours Service Interval Chart—Every 250 Hours..... 120-F-1 Engine Oil and Filter (Tier 2/Stage II and Tier 3/Stage IIIA) ............................... 120-F-2 Engine Oil and Filter (Final Tier 4/Stage IV).. 120-F-3 Fuel Tank Breather .......................................
120-F-3 Diesel Exhaust Fluid (DEF) Tank Breather (Final Tier 4/Stage IV) ............... 120-F-4 Maintenance—Every 400 Hours Service Interval Chart—Every 400 Hours.....120-G-1 Fuel Precleaner Filter ...................................120-G-1 Water Separator ...........................................120-G-2 Primary and Secondary Fuel Filter...............120-G-3 Variable Speed Driver/Driven Sheaves (Final Tier 4/Stage IV) (S760 and S770 Machines) .......................................120-G-4 Continued on next page xii 070717 PN=12