STARTING AND OPERATING 133 wheels are spinning (no traction). In this situation, the selected position indicator light will flash and the original position indicator light will remain on. At this time, reduce speed and stop spinning the wheels to complete the shift. Alternate Procedure E LECTRONICALLY S HIFTED T RANSFER C ASE (6-S PEED T RANSMISSION ) — I F E QUIPPED 1. Bring the vehicle to a complete stop. 2. With the ignition switch in the ON/RUN position and the engine running, shift the transmission into NEUTRAL. The electronically shifted transfer case is operated by the four-wheel drive Control Switch (Transfer Case Switch), which is located on the instrument panel.
2WD OR 4WD HIGH TO 4WD LOW 3. Push the desired position on the transfer case control switch. NOTE: When shifting into or out of 4WD LOW some gear noise may be heard. This noise is normal and is not detrimental to the vehicle or occupants. Shifting can be performed with the vehicle rolling 2 to 3mph (3 to 5km/h) or completely stopped. You can use either of the following procedures: 4. After the desired position indicator light is on (not flashing), shift the transmission back into gear. 4 NOTE:
Preferred Procedure If Steps 1 or 2 of either the Preferred or Alter nate Procedure are not satisfied prior to attempting the shift, then the desired position indicator light will flash continuously while the original position indicator light is on, until all requirements have been met. 1. With the engine running, slow the vehicle to 2 to 3mph (3 to 5km/h). 2. Shift the transmission into NEUTRAL. 3. While still rolling, push the desired position on the transfer case control switch. The ignition switch must be in the ON/RUN posi tion for a shift to take place and for the position indicator lights to be operable.
If the ignition switch is not in the ON/RUN position, the shift will not take place and no position indicator lights will be on or flashing. This electronically shifted transfer case provides four positions: Four-Position/Part-Time Transfer Case 4. After the desired position indicator light is on (not flashing), shift the transmission back into gear. Two-Wheel Drive High Range (2WD) Four-Wheel Drive High Range (4WD HIGH) Four-Wheel Drive Low Range (4WD LOW) N (Neutral)