144 STARTING AND OPERATING NOTE: The braking temperature exceeds normal range (overheated). Resume can be used at any speed above 0mph (0km/h) when ACC is active. Keeping your foot on the accelerator pedal can cause the vehicle to continue to accelerate beyond the set speed. If this occurs, the message “ACC DRIVER OVERRIDE” will display in the instrument cluster display. The trailer brake is applied manually (if equipped). NOTE: The following conditions will only cancel the ACC system: While in ACC mode, when the vehicle comes to a complete stop longer than two seconds, the system will cancel. The driver will have to apply the brakes to keep the vehicle at a standstill.
If you continue to accelerate beyond the set speed while ACC is enabled, the system will not be controlling the distance between your vehicle and the vehicle ahead. The vehicle speed will only be determined by the position of the accel erator pedal. To Cancel Driver seat belt is unbuckled at low speeds Driver door is opened at low speeds To Turn Off ACC cannot be resumed if there is a stationary vehicle in front of your vehicle in close proximity. The system will turn off and clear the set speed in memory if: WARNING! The Resume function should only be used if traffic and road conditions permit.
Resuming a set speed that is too high or too low for prevailing traffic and road conditions could cause the vehicle to accelerate or decelerate too sharply for safe operation. Failure to follow these warnings can result in a collision and death or serious personal injury. The following conditions cancel the ACC or Fixed Speed Cruise Control systems: The Adaptive Cruise Control (ACC) on/off button is pushed The brake pedal is applied. The Fixed Speed Cruise Control on/off button is pushed The CANCEL button is pushed. An Anti-Lock Brake System (ABS) event occurs. The ignition is placed in the OFF position 4WD Low is engaged To Resume The gear selector is removed from the DRIVE position.
To Vary The Speed Setting The Electronic Stability Control/Traction Control System (ESC/TCS) activates. If there is a set speed in memory push the RES (+) button and then remove your foot from the accelerator pedal. The instrument cluster display will display the last set speed. To Increase Or Decrease The Set Speed The vehicle parking brake is applied. After setting a speed, you can increase the set speed by pushing the RES (+) button, or decrease speed by pushing the SET (-) button. Driver seat belt is unbuckled at low speeds. Driver door is opened at low speeds. Resume can be used at any speed above 20mph (32km/h) when only Fixed Speed Cruise Control is being used.
A Trailer Sway Control (TSC) event occurs. The driver switches ESC to Full Off mode.