158 STARTING AND OPERATING If equipped with a Cargo Camera, a touchscreen button to switch the display to Cargo Camera image is made available whenever the Rear View Camera image is displayed. WARNING! Zoom View Drivers must be careful when backing up even when using the ParkView Rear Back Up Camera. Always check carefully behind your vehicle, and be sure to check for pedestrians, animals, other vehicles, obstructions, or blind spots before backing up. You are responsible for the safety of your surroundings and must continue to pay attention while backing up. Failure to do so can result in serious injury or death.
When the Rear View Camera image is being displayed, and the vehicle speed is below 8mph (13km/h) while in any gear selector position, Zoom View is available. By pressing the “magnifying glass” icon in the upper left of the display screen, the image will zoom in to four times the standard view. Pressing the icon a second time will return the view to the standard Back Up Camera display. A touchscreen button X to disable display of the camera image is made available when the vehicle is not in REVERSE gear. When enabled, active guidelines are overlaid on the Back Up Camera image to illustrate the width of the vehicle and its projected backup path based on the steering wheel position.
The active guidelines will show separate zones that will help indicate the distance to the rear of the vehicle. These settings can be adjusted within Uconnect Settings Ъ page189. When Zoom View is selected while the vehicle is in REVERSE, then shifted to DRIVE, the camera delay view will display the standard Back Up Camera view. If the vehicle is then returned to REVERSE gear from DRIVE, the Zoom View selection will automatically resume. CAUTION! To avoid vehicle damage, ParkView should only be used as a parking aid. The ParkView camera is unable to view every obstacle or object in your drive path.
A dashed center line overlay indicates the center of the vehicle to assist with parking or aligning to a hitch/receiver. The following table shows the approximate distances for each zone: Shifting to NEUTRAL from any gear will maintain the selected view (Zoom or Standard) as long as the vehicle is below 8mph (13km/h). To avoid vehicle damage, the vehicle must be driven slowly when using ParkView to be able to stop in time when an obstacle is seen. It is recommended that the driver look frequently over his/her shoulder when using ParkView. If the vehicle is in PARK, Zoom View is available until the gear selector is placed in DRIVE or REVERSE. NOTE: NOTE:
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the lens, rinse with water, and dry with a soft cloth. Do not cover the lens. If the vehicle is in DRIVE, NEUTRAL, or REVERSE, and speed is greater than or equal to 8mph (13km/h), Zoom View is unavailable and the icon will appear gray. While in Zoom View, the guidelines will not be visible. Zones Distance To The Rear Of The Vehicle Red 0 - 1ft (0 - 30 cm) Yellow 1ft - 6.5ft (30 cm - 2m) Green 6.5ft or greater (2m or greater)