FCA 2022 Chassis Cab — Before Plowing

STARTING AND OPERATING 181 Automatic Transmission Tow/Haul Mode must be connected to properly ensure operator safety and prevent overloading vehicle systems. The DRIVE range can be selected when towing. The transmission controls include a drive strategy to avoid frequent shifting when towing. However, if frequent shifting does occur while in DRIVE, select TOW/HAUL mode or select a lower gear range (using the Electronic Range Select (ERS) shift control). To reduce potential for automatic transmission overheating, activate TOW/HAUL mode when driving in hilly areas, or select a lower gear range (using the Electronic Range Select (ERS) shift control) on more severe grades.

Cruise Control — If Equipped Attaching a snowplow to this vehicle could adversely affect performance of the airbag system in a collision. Do not expect that the airbag will perform as described earlier in this manual. WARNING!­ NOTE: Using TOW/HAUL mode or selecting a lower gear range (using the ERS shift control) while operating the vehicle under heavy loading conditions will improve performance and extend transmission life by reducing excessive shifting and heat build-up. This action will also provide better engine braking. 6-Speed Automatic Transmission Only Do not use on hilly terrain or with heavy loads.

When using the Cruise Control, if you experience speed drops greater than 10­mph (16­km/h), disengage until you can get back to cruising speed. 4 The “Lamp Out” indicator could illuminate if exterior lamps are not properly installed. CAUTION!­ Use Cruise Control in flat terrain and with light loads to maximize fuel efficiency. SNOWPLOW — IF EQUIPPED When towing a loaded trailer up steep grades at low speeds (20­mph [32­km/h] or below), holding your vehicle in FIRST gear (using the ERS shift control) can help to avoid transmission overheating. B EFORE P LOWING Snowplow Prep Packages are available as a factory installed option.

These packages include components necessary to equip your vehicle with a snowplow. Check the hydraulic system for leaks and proper fluid level. Check the mounting bolts and nuts for proper tightness. If you regularly tow a trailer for more than 45­minutes of continuous operation, then change the automatic transmission fluid and filter(s) as specified for "police, taxi, fleet, or frequent trailer towing." Ъ ­page­324. NOTE: Before installation of a snowplow it is highly recom­ mended that the owner/installer obtain and follow the recommendations contained within the current Body Builder’s Guide. See an authorized dealer, installer or snowplow manufacturer for this infor­ mation.

There are unique electrical systems that Check the runners and cutting edge for exces­ sive wear. The cutting edge should be ј to Ѕ inches (6 cm to 1.2 cm) above ground in snow plowing position. NOTE: Check the automatic transmission fluid level before towing (6-speed automatic only). Check that snowplow lighting is connected and functioning properly.