228 MULTIMEDIA Automatic reply messages can be: TOGGLING BETWEEN CALLS call(s) will be terminated and if there is a call on hold, it will become the new active call. “I am driving right now, I will get back to you shortly”. REDIAL Create a custom auto reply message up to 160 characters. Push the VR button and after the “Listening” prompt and the following beep, say “Redial.” NOTE: Only the first 25 characters can be seen on the touchscreen while typing a custom message. While in Do Not Disturb, “Conference Call” can be selected so you can still place a second call without being interrupted by incoming calls. The Uconnect Phone will call the last number that was dialed from your mobile phone.
CALL CONTINUATION NOTE: Uconnect 3 With 5-inch Display Call continuation is the progression of a phone call on the Uconnect Phone after the vehicle ignition has been switched to OFF. Reply with text message is not compatible with iPhone® devices. If two calls are in progress (one active and one on hold), press the Swap Calls button on the phone main screen. Only one call can be placed on hold at a time. NOTE: The call will remain within the vehicle audio system until the phone becomes out of range for the Bluetooth® connection. It is recommended to press the Transfer button on the touchscreen when leaving the vehicle.
Advanced Phone Connectivity Auto reply with text message is only available on phones that support Bluetooth® Message Access Profile (MAP). You can also push the Phone button to toggle between the active and held phone call. PLACE/RETRIEVE A CALL FROM HOLD During an active call, press the Hold or Call On Hold button on the Phone main screen. JOIN CALLS When two calls are in progress (one active and one on hold), press the Join/Merge Calls button on the Phone main screen to combine all calls into a conference call.
TRANSFER CALL TO AND FROM MOBILE PHONE MAKING A SECOND CALL WHILE CURRENT CALL IS IN PROGRESS The Uconnect Phone allows ongoing calls to be transferred from your mobile phone without terminating the call. To transfer an ongoing call from your connected mobile phone to the Uconnect Phone or vice versa, press the Transfer button on the Phone main screen. You can place a call on hold by pressing the Hold button on the Phone main screen, then dial a number from the keypad (if supported by your mobile phone), recent calls, SMS Inbox or from the phonebooks.
CALL TERMINATION To end a call in progress, momentarily press the End Call button on the touchscreen or the Phone End button on the steering wheel. Only the active