44 GETTING TO KNOW YOUR VEHICLE E RASING A LL T HE H OME L INK ® C HANNELS not be immediately visible when looking at the device. The name and color of the button may vary slightly by manufacturer. 3. Push and hold the HomeLink® button you want to program while you push and hold the garage door opener transmitter button you are trying to replicate. To erase the channels, follow this procedure: 1. Place the ignition switch into the ON/RUN position. NOTE: The “LEARN” or “TRAIN” button is not the button you normally use to operate the device. Non-rolling Code Devices 4. Continue to hold both buttons and observe the HomeLink® indicator light.
The HomeLink® indicator light will flash slowly and then rapidly. Once this happens, release both buttons. 2. Push and hold the two outside HomeLink® buttons (I and III) for up to 20 seconds, or until the HomeLink® indicator light flashes. Most devices manufactured before 1995 will not have a rolling code. These devices will also not have a “LEARN” or “TRAIN” button. P ROGRAMMING H OME L INK ® T O A G ARAGE D OOR O PENER NOTE: Erasing all channels should only be performed when programming HomeLink® for the first time. Do not erase channels when programming addi tional buttons. I DENTIFYING W HETHER Y OU H AVE A R OLLING C ODE O R N ON -R OLLING C ODE D EVICE NOTE:
Make sure the garage door opener motor is plugged in before moving on to the rolling code/ non-rolling code final steps. Rolling Code Garage Door Opener Final Steps To program any of the HomeLink® buttons to activate your garage door opener motor, proceed as follows: NOTE: You have 30 seconds in which to initiate rolling code final step 2, after completing rolling code final step 1. 1. At the garage door opener motor (in the garage), locate the “LEARN” or “TRAIN” button. This can usually be found where the hanging antenna wire is attached to the garage door opener motor. Firmly push and release the “LEARN” or “TRAIN” button. NOTE: All HomeLink® buttons are programmed using this procedure.
You do not need to erase all channels when programming additional buttons. 1. Place the ignition switch into the ON/RUN position. Before programming a device to one of your HomeLink® buttons, you must determine whether the device has a rolling code or non-rolling code. Rolling Code Devices To determine if your device has a rolling code, a good indicator is its manufacturing date. Typically, devices manufactured after 1995 have rolling codes. A device with a rolling code will also have a “LEARN” or “TRAIN” button located where the antenna is attached to the device. The button may 2.
Place the garage door opener transmitter 1 to 3inches (3 to 8 cm) away from the HomeLink® button you wish to program, while keeping the HomeLink® indicator light in view. 2. Return to the vehicle and push the programmed HomeLink® button three times (holding the button for two seconds each time). If the garage door opener motor operates, programming is complete.