46 GETTING TO KNOW YOUR VEHICLE 1. Place the ignition in the ON/RUN position. Reprogramming A Single HomeLink® Button (Canadian/Gate Operator) Push the LEARN button on the Garage Door Opener to complete the training for a Rolling Code. 2. Place the hand-held transmitter 1 to 3inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. To reprogram a channel that has been previously trained, follow these steps: 1. Place the ignition in the ON/RUN position. Did you unplug the device for programming and remember to plug it back in? 3.
Continue to press and hold the HomeLink® button, while you press and release (cycle) your hand-held transmitter every two seconds until HomeLink® has successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained. 2. Press and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. Do not release the button. If you have any problems, or require assistance, please call toll-free 1-800-355-3515 or, on the Internet at HomeLink.com for information or assistance. 3. Without releasing the button, proceed with “Canadian/Gate Operator Programming” step 2 and follow all remaining steps. WARNING! 4.
Watch for the HomeLink® indicator to change flash rates. When it changes, it is programmed. It may take up to 30 seconds or longer in rare cases. The garage door may open and close while you are programming. S ECURITY Vehicle exhaust contains carbon monoxide, a dangerous gas. Do not run your vehicle in the garage while programming the transceiver. Exhaust gas can cause serious injury or death. It is advised to erase all channels before you sell or turn in your vehicle. 5. Press and hold the programmed HomeLink® button and observe the indicator light. To do this, push and hold the two outside buttons for 20 seconds until the indicator flashes. Note that all channels will be erased.
Individual channels cannot be erased. Your motorized door or gate will open and close while you are programming the universal transceiver. Do not program the transceiver if people, pets or other objects are in the path of the door or gate. Only use this transceiver with a garage door opener that has a “stop and reverse” feature as required by Federal safety standards. This includes most garage door opener models manufactured after 1982. Do not use a garage door opener without these safety features. NOTE: If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink® button is pressed.
The HomeLink® Universal Transceiver is disabled when the Vehicle Security system is active. T ROUBLESHOOTING T IPS To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels. If you are having trouble programming HomeLink®, here are some of the most common solutions: If you unplugged the garage door opener/device for programming, plug it back in at this time. Replace the battery in the Garage Door Opener hand-held transmitter.