24.2.7 CHECK FOR LOOSE TRACK SHOE BOLTS, TIGHTEN If the track is used when track shoe bolts @ are loose, they will be damaged. If any loose bolts are found, tighten them immediately. Method for tightening (shoe bolt) 1. First tighten to a tightening torque of 196 + 20 Nm (20 + 2 kgm, 145 f 14 Ibft), then check that the nut and shoe are in close contact with the link contact surface. 2. After checking, tighten a further 120” + 10”. Method for tightening (master link connecting bolt) 1. First tighten to a tightening torque of 196 f 20 Nm (20 f 2 kgm, 145 f 14 Ibft), then check that the link contact surfaces are in close contact. 2. After checking, tighten a further 180” + 10”.
I AD053090 1 24.2.8 DRAIN WATER FROM WATER SEPARATOR When float @ is at or above red line 0, drain the water according to the following procedure: Loosen drain plug @ and drain the accumulated water until the float reaches the bottom. Tighten drain plug 0. If the air is sucked into fuel line when drain the water, be sure to bleed air in the same manner as for the fuel filter. (See Fuel Filter Cartridge in “24.6 EVERY 500 HOURS SERVICE” section.) 1. 2. 3. AE080171 3-33