24. SERVICE PROCEDURE 8. After replacing the filter cartridge, add engine oil through oil filler @ until the oil level is between the H and L marks on the dipstick. For details of the oil to use, see “20. USE OF FUEL, COOLANT, AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. When adding oil, be careful not to get oil on the alternator. 9. Idle-run the engine for a short time, then stop the engine, and check that the oil level is between the H and L marks on the dipstick. For details, see “24.3 CHECKS BEFORE STARTING”. NOTICE Change the engine oil and replace the filter once every 6 months regardless of the amount of time the machine has been operated.
24.6.3 REPLACE STEERING CLUTCH CASE OIL FILTER ELEMENT Remove the floor plate. Remove bolt @ and remove cover @ to take out spring 0, valve @ and element 0. Clean inside of case and removed parts, and install a new element. Fill case with oil and fix cover @ with bolts 0. AE080780 After replacement of element, loosen air vent plug @ and start engine. Overflow oil until no air bubble comes out from plug @ and tighten plug 0. Always use a genuine Komatsu element. AE080790 3-52