CHECK OIL LEVEL IN STEERING CLUTCH CASE (INCL. BEVEL GEAR CASE), ADD OIL 1. Open the cover, remove dipstick 0, and wipe the oil off with a cloth. Insert dipstick @ fully in the oil filler pipe, then take it out again. The oil level should be between the H and L marks on dipstick 2. 3. 0. If the oil level is below the L mark, add engine oil through oil filler 0. For details of the oil to use, see “20. USE OF FUEL, COOLANT, AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. 4. If the oil is above the H mark, drain the excess engine oil from drain plug @, and check the oil level again. 5. If the oil level is correct, tighten the oil filler cap securely and close the cover.
REMARK When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before check- ing. If the machine is at an angle, make it horizontal before checking. In case the work is carried out on sloped land of more than 25” declination, supply oil up to H level. AE080160 2-19