Lubrication system Cleaning the centrifugal oil cleaner WARNING! The oil may be hot. Carefully remove the cover from the centrifugal oil cleaner. Tools Illustration Torque wrench 2-20 Nm with exchangeable ratchet head 364 731 364 729 Ratchet head When the centrifugal oil cleaner is cleaned, there should be some dirt deposits in the rotor cover. This indicates that the rotor is working. If the ro- tor cover is clean, in other words the rotor is not working, the cause must be established immedi- ately. If the dirt deposits exceed 28 mm (1.1 in) at the recommended intervals, the rotor cover should be cleaned more often. x 1.5 1. Clean the cover. Unscrew the nut securing the outer cover. 2.
Let the oil run out from the rotor. 3. Lift out the rotor. Wipe off the outside. Undo the rotor nut and unscrew it about 1.5 turns to protect the bearing. Note: Take care not to damage the rotor shaft. 133 315 00:23-02 en-GB 12 © Scania CV AB 2016, Sweden