Operation 3.3. Operation NOTE Do not fill in too much oil in one go via the filler! 4. Wait three minutes before you check the oil level again. If the oil level is above the (H) marking, drain off some oil. (see section "Draining engine oil" on page 3-37). 5. Close the oil filler (2). Draining engine oil If you have topped up too much oil, you must drain off the excess oil. Have an oil trough with a sufficient capacity ready. 1. Put the oil trough under the drain screw. 2. Remove the cover cap (1) from the drain valve. 3. Screw on the drain hose (2) on the drain valve. This will cause the drain valve to open. 4. Drain the oil. 5. Remove the drain hose (2) from the drain valve.
This will cause the drain valve to close. 1 6. Check oil level again. 7. Fit cap (1) back onto drain valve. WA100M-5 – VEAM280201 3-37