Operation 3.3. Operation Adjustments prior to machine start Adjusting the driver’s seat After each change of the driver, newly adjust the driver’s seat. Before you start operation, check that the seat is adjusted in such a way that you can fully floor the brake pedal when you lean against the backrest. Proceed as follows to adjust the seat according to your requirements: Modell: ISRI (1) Weight adjustment Turn the handwheel (1) to set the vibration absorbing system to the weight of the driver. (2) Adjustment of horizontal position To adjust the horizontal seating position, pull the lever (2) and slide the seat forward or backward. To lock the position of the seat, release the lever again.
(3/4)Adjusting height and angle of inclination 5 You may adjust the height and the angle of inclination of the driver’s seat with the spring-supported levers (3) and (4). 1 Use lever (3) to set the front part of the seat, use lever (4) to set the rear part of the seat. . 4 Adjusting the seat’s height Adjust the front and the rear section of the seat uniformly. 2 3 For this purpose, pull lever (3) and hold it in this position. To lift up the front part of the seat, it is necessary to relieve your weight from the front section of the seat cushion by standing up. Then, sit down on the front part in order to press down the front section of the seat.
Release the lever if you have reached the right position. The seat is now locked in its position. Then, pull lever (4) and hold it in this position. To lift up the rear part of the seat, it is necessary to relieve your weight from the rear section of the seat cushion by standing up. Then, sit down on the rear part in order to press down the rear section of the seat. Release the lever if you have reached the right position. The seat is now locked in its position. Adjusting the angle of inclination of the seat Adjust the front and rear section of the seat with different settings. Proceed as described above. WA100M-5 – VEAM280201 3-41