3.2. Description of the individual elements Operation Switching on the low beam Continue to turn the light switch until it reaches position '2'. All lights which were already switched on in position '1' (parking light) remain lit. In addition, the low beam is switched on. The low beam control lamp lights up. How to flash one’s lights (high beam) In order to flash your lights, you need to draw the lever briefly in the direction of the steering wheel. The high beam is only switched on as long as you draw the lever. The high beam control lamp will also light up for that time. Switching on the high beam In order to switch on the high beam you must press the lever completely down.
In this position the lever locks in and the high beam control lamp lights up. 7. Driving direction switch You can change the driving direction of the machine with the driving direction switch.. Position F = Forward driving Position N = Neutral position Position R = Reverse driving NOTE You can only start the engine if the driving direction switch is switched to the neutral position 'N'. 8. Start switch You can start and switch off the engine with the start switch. 0 I '0': Stop position In this position, the engine is switched off, permitting you to remove the ignition key. All functional circuits are interrupted in the stop position. P II 'I':
Operating position The control lamps light up in the operating position 'I' and the air preheater is in operation. All functional circuits are activated. The ignition key remains in this position with the engine running. 75_209 'II': Start position In start position 'II', the engine starts. NOTE You may only start the engine, if the driving direction switch is set to the neutral position 'N'. 3-18 WA100M-5 – VEAM280201