4 Angle finder C4282 3 Place the angle finder on the heel of the pedal to be checked or adjusted. (fig. C2050) Note the reading. Checking the pedal angle C2050 4 Adjust the pedal angles by turning the cable nuts on either side of the bulk heads, front and / or rear. Adjust the lift and tilt pedal angle to 15є. The auxiliary pedal angle is factory set at 20 є. Be sure to allow for the base angle measurement taken previously. Example: If the base angle measured 3є, add or subtract that angle from the angle measured on the pedal. 5 Tighten the cable nuts against the bulk heads, front and rear. tighten the jam nuts on the cable ends if not already done.
Check the control cable operation by cycling the pedals. Operation should be smooth and the pedal should have unrestricted travel when heeled and toed. If binding is occurring the control valve spools or electric lock system may need servicing. Adjusting the pedal angle Cable nuts C2013 4-15 FOOT PEDALS 4.2 Angle Adjustment 1300/135 Maintain 3/8’’ (6mm) thread contact Cable clevis Jam nut C617 After changing the control cable the foot pedal angle will need to be verified and / or adjusted to provide operator comfort and proper pedal travel clearance. Note: If the operator feels discomfort due to current pedal angles, they may be adjusted to their preference.
Be sure to check for pedal travel clearance afterward. Always maintain a minimum of 3/8’’ (6mm) of thread into the cable clevis and eyelet cable ends. (fig. C617) 1 Make sure the cable ends are screwed onto the cable threads a minimum of 3/8’’ (6mm). (fig. C617) 2 Place an angle finder on the inner fender of the loader to find the base measurement. Note the reading. (fig. C4282) C617