4 4-17 FOOT PEDALS 4.2 Foot Pedal Replacement 1300/135 Remove cotter pins C2010 Remove shaft bolt C2016 Pedal removal Spacer washers C2281 Remove cotter pins C2010 If the foot pedals or shaft need replacement due to dam- age or wear: 1 Raise the boom arms, engage the boom supports and shut off the engine. WARNING Never work under the boom arms without the boom supports engaged. 2 Remove the seat and hydrostatic shield. 3 Remove the cable clevis cotter pins. (fig. C2010) 4 Remove the bolt retaining the foot pedal shaft to the side mount. (fig. C2016) C2010 5 Slide the shaft clear over to right hand side and remove and save any spacer washer if present.
6 Tip the loose end of the shaft up and remove the complete pedal and shaft assembly together. Keep count of the spacer washer used if present. They are used to align the pedals with the cables. 7 Replace worn parts as required. The foot pedals are equipped with bronze oillite bushings that are pressed into place and machined to size afterward. They are not serviceable separately. The complete pedal must be replaced. 8 Reinstall pedals in the reverse order. Be sure to add spacer washers as required to either end of the foot pedal shaft to align the pedals with the cables. Failure to align the pedal and cables properly will cause stiffness, binding and / or premature cable wear.
Total pedal movement side to side, end play, should not exceed 1 / 8”.