whenever the engine is started, or when the control levers are released. If the loader creeps (not in neutral) when the engine is started or when the steering lever is released from for- ward or reverse position, the hydroback device may need to be adjusted, repaired or replaced. 1 Raise the boom arms, engage the boom support pins and shut off the engine. Raise and block the loader securely off the ground. Hydrostatic shield 4 WARNING C4281 Never work under the boom arms without the boom supports engaged. Hydroback location 2 Remove the seat (fig. C4280) and hydrostatic shield.(fig. C4281) Note the location of the hydroback. (fig.
C2025) 3 Cycle the control lever while watching the hydroback action. The hydroback should have a positive feel to it as the lever is in the neutral position. 4 Check the rod ends on each end of the hydroback. They must be free of any play. Replace the rod ends if any play or slack is noticed. (fig. C1638) 5 If the control lever is able to move slightly without spring tension returning it to neutral, the hydroback needs adjustment. Adjustment C2025 Hydroback assembly 2 Jam nuts IMPORTANT Repairs or adjustment to the control lever system may change the loader neutral position. Make sure the loader is raised securely off the ground before restarting the engine.
Jam nut C1638 Rod ends 4-5 STEERING 4.1 Neutral Adjustment Remove seat assembly C4280 IMPORTANT If you are unfamiliar with the control operations of the loader, read the Owner’s / Operator’s Manual beforehand. C4280