SAFETY, NOISE AND VIBRATION PLATES 2.1.3 POSITION OF THE NOISE PLATES q The noise plates must always be legible and in good condi- tions; for this reason, if they are dirty with dust, oil or grease, it is necessary to clean them with a solution made of water and detergent. Do not use fuel, petrol or solvents. q If the plates are damaged, ask for new ones to Komatsu or to your Komatsu Dealer. q In case of replacement of a component provided with a noi- se plate, make sure that this plate is applied also on the new part.
RWA37050 NOISE OUTSIDE THE CAB q This value indicates the noise level outside the machine and refers to the noise perceived by the persons who are in the vicinity of the work area. 2000/14/EC RWA37060 10 dB 1 NOISE INSIDE THE CAB q This value indicates the maximum noise level perceived by the operatorнs ears inside the cab. RWA36350 ISO 6396 8 dB 6 2.1.4 VIBRATIONS TO WHICH THE OPERATOR IS SUBJECTED q According to the results of the tests carried out to determine the vibrations transmitted to the operator by the ma- chine, the upper limbs are subjected to vibrations lower than 2.5 m/sq.sec., while the seated part of the body is subjected to vibrations lower than 0.5 m/sq sec. 23