SAFETY PRECAUTIONS BEFORE STARTING OPERATIONS The operator is responsible for the safe operation of this machine at all times, regardless of the situation. Although Komatsu cannot cover all operating conditions that pose a major hazard, here are a few basic situations to avoid when using the loader during work or travel operations. It is advisable to study these and always be aware of them before starting work operations. Failure to do so may result in damage to the machine or injury to the operator and other personnel. Pre-Operational Checks Before starting your work operations, it is important to perform a Pre-operational Check to be sure your equipment is in safe operating condition.
If any problems are found during your pre-operational check, have them repaired immediately. Never operate a machine that is unsafe, damaged, or in need of repair. Failure to perform a pre-operational check before starting work operations may result in damage to the machine or injury to the operator and other personnel. Remark It is important that a pre-operational check be performed at the beginning of your work shift. Even if you are taking the machine operations over from another operator, always perform a pre-operational check before you start work.
Ensure Good Visibility This machine is equipped with mirrors to improve visibility but, even with mirrors, there are blind spots which cannot be seen from the operator’s seat. Always be careful when operating the machine. When operating or traveling in places with poor visibility, it is impossible to check for obstacles in the area around the machine and to check the condition of the job site. This leads to danger of serious personal injury or death. When traveling or carrying out operations in places with poor visibility, always observe the following rules: If visibility is not sufficient, position a flagman.
The operator should pay close attention to the signs and follow all of the flagman’s instructions. Signals should be given by only one flagman. When working in dark places, turn the machine’s working and front lamps on and, if necessary, set up additional lighting in the area. Stop operations if the poor visibility is due to fog, snow, rain, or dust. Clean the windows and mirrors on the machine then adjust all mirrors to ensure good visibility before starting operations every day. Signs and Signals On road shoulders or soft ground, set up signs to inform personnel of conditions. Make sure all personnel understand the meaning of all the signs.
If the operators do not know the condition of a job site, the machine may tip over or fall, resulting in injury to the operator. If the visibility is not good, position a signalman. Operators should pay careful attention to the signs and follow the instructions from the signalman. Only one signalman should give signals. 1-26 WA430-6