SAFETY Stopping Engine During Inspection and Maintenance To prevent personal injury, do not carry out maintenance with the engine running. If maintenance must be carried out with the engine running, follow the procedure described by “Running the Machine During Maintenance” on page 1-44. 1. Lower the work equipment completely to the ground and stop the engine before performing any inspection and maintenance. 2. After stopping the engine, turn the starting switch to the ON position and operate work equipment control lever (1) fully in the RAISE and LOWER directions two to three times to release the remaining pressure in the hydraulic circuit. 3.
Set work equipment lock lever (2) to the LOCK position (L). After releasing the remaining pressure in the hydraulic circuit, turn the starting switch to the OFF position. 4. Set parking brake switch (3) to the ON position (A) to apply the parking brake. 5. Put blocks in front of and behind the tires to prevent the machine from moving. 1-42 WA430-6