There can be increased skipping, difficulty in recording tracks, difficulty in finding tracks, and/or difficulty in loading and ejecting. If these problems occur, check the disc for damage or try a known good disc. Do not apply labels to discs. (The labels could get caught in the player). Keep the loading slot free of foreign materials, liquids, and debris. 2. Insert a disc into the slot, label side up. The player pulls it in the rest of the way. If the disc is damaged or improperly loaded, there is an error on the screen and the disc ejects. 3. Press “Eject” to eject a disc from the CD player.
If the disc is not removed within a short period of time, it is automatically pulled back into the player. 1. After the CD is inserted, the mode is changed to CD mode, unless any mode with a higher priority is active (I.E. phone call, video, reverse mute….). 2. To control and browse the selected media source refer to sections Media Sources and Media Audio Control Soft key for further information. If a “ Disc Error ” message is displayed and/or the disc comes out, it could be for one of the following reasons: The disc is very hot. Try the disc again when the temperature returns to normal. The road is very rough. Try the disc again when the road is smoother.
18 | P a g e Use a marking pen to label the top of the disc. Do not use scratched or damaged discs. The disc has an invalid or unknown format. To avoid damage to the CD player: Insert only one disc at a time. 1. Turn the vehicle on. Ownerґs Manual DEA600 Radio Playing an Audio CD: To load a disc: Error Messages 3. Radio will start playing the USB and shows the track number, Song, Artist, elapsed time, and Album information when available. 4. If the iPod is an unsupported model, it can still be listened to in the vehicle by connecting to the auxiliary input jack using a standard 3.5 mm (1/8 in) stereo cable. 5.
To control and browse the selected media source refer to sections Media Sources and Media Audio Control Soft key for further information. Expected behavior when iPod is connected: The iPod shuts off and stops charging when the vehicle is shut off. If an “UNSUPPORTED” message is displayed, it could be for one of the following reasons: The iPod does not respond to the radio commands, in this case reset the iPod and try again the connection. If a “NO MUSIC” message is displayed, it could be because there are no playable files in the iPod. The player can be used for CD and MP3 audio. With the vehicle on, insert a disc into the slot, label side up, the player pulls it in and begins playing.
The system is capable of playing: MP3. When playing any compatible recordable disc, the sound quality can be reduced due to disc quality, the method of recording, the quality of the music that has been recorded, or the way the disc has been handled. The iPod battery recharges automatically while the vehicle is on. When the iPod connected is not supported. Most audio CDs. Error Messages CD-R. CD-RW. CD Player